Linksys
AM300
Default IP: 192.168.1.1
Default username : admin
Default password : admin
Setting Bridge
1. Pilih Setup
2. Pilih Basic Setup
3. ADSL Settings, Encapsulation: RFC 1483 Bridged, Autodetect: Disable, VPI: 8, VCI: 81, Multiplexing: LLC, DSL Modulation: Auto
4. Pilih Save Settings
Setting PPPoE
1. Pilih Setup
2. Pilih Basic Setup
3. ADSL Settings, Encapsulation: RFC 2516 PPPoE, Autodetect: Disable, VPI: 8, VCI: 81, Multiplexing: LLC, DSL Modulation: Auto
4. PPPoE Settings: Username: (nmrspeedy@telkom.net), Password: (password speedy), Keep Alive
5. Pilih Save Settings
Readmore.........
Zyxel
P-660R
Default IP: 192.168.1.1
Default username : admin
Default password : 1234
Setting Bridge
1. Pilih Network
2. Pilih WAN
3. Mode: Bridge, Encapsulation: RFC 1483, Multiplexing: LLC, VPI: 8, VCI: 81, Apply
4. Pilih Maintenance
5. Pilih Tools
6. Restart
Setting PPPoE
1. Pilih Network
2. Pilih WAN
3. Mode: Routing, Encapsulation: PPPoE, Username: (nmrspeedy@telkom.net), Password: (password speedy), Service Name: Speedy, Multiplexing: LLC, VPI: 8, VCI: 81, IP Address: Obtain an IP Address Automatically, Connection: Nailed-Up Connnection, Apply
4. Pilih Maintenance
5. Pilih Tools
6. Restart
Readmore.........
1. Go into my computer > dial up networking > right click on dialer > goto properties.
2. check correct modem is selected in connect using. If incorrect click on drop down list and pick correct modem.
3. click on OK and try connecting again.
4. If that fails go into control panel > modems > check to see if correct modem is installed. if not remove modem and re-install.
5. If that does not work try creating a new dialer.
Readmore.........